HOLIDAY SEASON SUPER SPECIAL - Save $15!!
Was $55 - Now $39.99
The Hyperboost O2 module is precise electronic computer chip that will increase the power of your engine. The Hyperboost module connects to your vehicle's O2 Sensor and continually monitors the air/fuel ratio to increase peak horsepower.
Couple a Hyperboost power module with our X2 Power Performance Chip for MAXIMUM horsepower gains - anywhere from 50 - 70 horsepower!
The Hyperboost unit takes removes the barriers placed on the ECU by modifying the O2 sensor signal the device modifies the voltage signals of oxygen sensor and allows more fuel to be pumped to the injectors. This, in turn, delivers between 10-20 horsepower plus notable increases in low end torque. The Oxygen Performance module will tune your vehicle for POWER not emissions - AND it will still allow you to pass emissions testing!
FEATURES OF THE HYPERBOOST O2 SENSOR
- Improves engine power by as much as 20 horsepower.
- Increased throttle response, acceleration and low end torque.
- Does not trigger check engine light and preserves smog certification.
- Easy to install- 15-20 minutes installation.
- Effects are immediate - there is no ECU learning period.
- Reduces flat spots in power band.
- Lifetime warranty
*For maximum results combine with our X2 Power Chip.
*Two Hyperboost are required if you have 2 rear catalytic converters
OPERATION OF OXYGEN SENSOR POWERCHIP
This device modifies voltage signals on your oxygen sensor. ECU lets more fuel to the injectors while air-fuel mixture is modified. This can influence the mixture adjustment gaining more power, enhancing the efficiency of combustion and saving fuel.
We improve the power slightly at the expense of exhaust emission.
HOW IS SUCH AN ENHANCED RESULT POSSIBLE?
The operation of injection / ignition system is significantly determined by the voltage of the oxygen sensor, therefore when the chip modifies this signal we may regulate effectively engine output. Hyperboost unleashes lots power of your stock engine by turning off some engineering restrictions applied by the car manufacturer. This does not hurt your car or significantly effect emissions.
|
|

|
- 8-10% + HP
- 8-10 % + Torque
- 15-20 % + acceleration
- higher top speed
- diminished flat spots
- improved throttle response
|
|
|
Effect time:
|
immediate
|
|
|
Switch:
|
can be connected
|
|
|
Facture:
|
chromium body with melted epoxy
|
|
|
Model range:
|
full
- to 1,2,3,4,5 wire oxygen sensors
- to zirconia or titania sensors
|
|
|
Installation:
|
easy with twist locks
|
|
|
Connection:
|
only to properly working OEM sensor
|
|
|
Warranty
|
Lifetime
|
|
|
Smog certification:
|
preserved
|
|
|
INCLUDED:
|
- Hyperboost Module
- 4 pcs twistlocks (blue)
- 2 pcs. cable duct (red)
- 4 pcs insulator tube (yellow)
- exhaust clip
- 2 pcs plastic cable clamps
- Installation guide
|